Are you Facing trouble in finding your product?      Please write us email at

Digital Multimeter - DT830

Digital Multimeter - DT830

Digital Multimeter - DT830

830 series multimeters are pocket-sized 3 1/2-digit digital multimeters for measuring DC and AC Voltage, DC Current, Resistance and Testing Diode. Some models also provide transistor test function, signal output or performing continuity test. Overload protection and low battery indication are provided.

  • FUNCTION AND RANGE SWITCH-This switch is used to select the functions and desired ranges as well as to turn ON/OFF the meter.To extend the life of the battery, the switch should be in the "OFF" position when the meter is not in use.
  • DISPLAY 3 1/2 digits, LCD(12mm)
  • "COM" JACK Plug in connector for black (negative) test lead.
  • JACK Plug in connector for red (positive) test lead for all voltage, resistance and current ( up to 200mA ) measurements.
  • "10A"JACK
  • LIGHT SWITCH ( only for DT830BL ) Switch for " torch light " and " back light "

Note-Plug in connector for red (Positive) test lead for current ( between 200mA and 10A ) measurement. There is no fuse for "10A" jack. To use safely, each measurement can not last for more than 10 seconds, and the interval between each measurement must be more than 15 minutes.

  • Diode: Testing Voltage about 2.8V, current about 1mA. The approximate forward voltage drop in mV will be displayed.
  • Buzzer: The buzzer will sound when it is less than about 50 ohm. 
  •  Signal output: square wave ( 50Hz ) or sine wave ( 1000Hz ). Level output: 5Vp-p

Write a review

Note: HTML is not translated!
    Bad           Good

  • Views: 1448
  • Product Code: DT830
  • Availability: In Stock
  • Rs180.00

Tags: digital, multimeter, dt830, digital multimeter

5 Pin Female Single Side Jumper Wire -25%
5 Pin Jumper Wire (Female) Single Sided Connector 20-30cm Wire LengthThis is a simple five wire cabl..
Rs20.00 Rs15.00
A continuity tester is an item of electrical test equipment used to determine if an electrical path ..
The Electrical tester is  used to detection of Electrical energy or flow of current in the circ..
The DT-266 Digital Clamp Meter can be used for AC/DC voltage test, AC current test, electric current..
A Banana Plug has a prong contact and a Banana Jack has a socket/receptacle contact. The contact may..
This is the new Arduino Uno R3. In addition to all the features of the previous board, the Uno now u..
Get the Link 3.5mm Male to Male Audio Cable 1 Meter to achieve clear, reliable sound. Use ..
Raspberry Pi Model B+ 512MB RAMThe Raspberry Pi Model B+ 512MB is a credit card sized computer that ..
Soldering Flux/ PastThis electronic-quality soldering flux is mixed with petroleum jelly and ideal f..
Arduino Nano 3.0 ATmega328The Arduino Nano is a compact, open source ,based on the ATmega328 low pr..