If you not find your right product!      Write us email at   sales@component7.com.

Arduino Nano V3.0 Prototype Shield I/O Extension Board

New Arduino Nano V3.0 Prototype Shield I/O Extension Board

Arduino Nano and Pro is too small to connect to jumper wires or breadboard. Nano IO Expansion Shield is specifically designed to facilitate an easy connection between Nano and many other devices. In essence, it expands the Nano controller to link those devices in a simple and trouble free manner. It is used for Arduino Nano direct if you seal the Pin of the board also compatible with Arduino Duemilanove and UNO. It is a perfect companion of Nano breadboard and compatible with both FOR Arduino Nano v2.x and v3.x.


  • 14 I/ O Pin (servo type with GND, power, and signal)
  • 8 analog Pin with power output and GND
  • 6 PWM Pin
  • 1 Servo power input
  • I2C expansion Pin
  • AREF output
  • 3.3V output

Write a review

Note: HTML is not translated!
    Bad           Good

  • Views: 17
  • Product Code: Nano I/O Extension Board
  • Availability: In Stock
  • Rs249.00

Tags: Arduino Nano, I/O Extension Board

Arduino Nano 3.0 ATmega328The Arduino Nano is a compact, open source ,based on the ATmega328 low pr..

Arduino Ethernet Shield -45%
The Arduino Ethernet Shield connects your Arduino to the internet in mere minutes. Just plug this m..
Rs999.00 Rs549.00

Arduino Motor Shield -17%
Arduino Motor ShieldThe Arduino Motor Shield is based on the L298, which is a dual full-bridge driv..
Rs3,000.00 Rs2,499.00

L293D motor control shield for Arduino New
The shield contains two L293D motor drivers and one 74HC595 shift register.L293D is a monolithic int..