Arduino Pro Mini Atmega 328P
Arduino Pro Mini is intended for advanced users who require flexibility,
low-cost, and small size. It comes with the minimum of components (no on-board
USB or pin headers) to keep the cost down. Be sure to provide the correct power
and use components whose operating voltage matches that of the board.
The board comes without built-in USB circuitry,
so an off-board USB-to-TTL serial convertor must be used to upload sketches.
This can be a FTDI TTL-232R USB - TTL Level Serial Converter
Cable for the 5V Arduino Mini Pro), or a FTDI TTL-232R-3V3 USB - TTL
Level Serial Converter Cable. One quick way to connect these is by inserting a
six-pin 0.1" male pin header into the end of the FTDI cable or breakout
board, and pressing it against the six hole programming header on the Mini Pro.
If, however, you're going to be uploading lots of sketches to your Pro Mini,
you'll probably want to solder some pins (male headers) to the holes.
The board can be powered through USB via the six-pin programming header, or from a regulated 5V (depending on the model) supply applied to the VCC pin or an unregulated supply on the RAW pin.
Any standard 0.1" spaced header can be soldered to the holes on the Arduino Pro Mini. To use every pin requires two 12-pin headers, plus a six pin header for programming, if desired. Bare wire can also be soldered directly to the holes.
- ATmega328 running at 16MHz with
external resonator (0.5% tolerance)
- 0.8mm Thin PCB
- USB connection
- 5V regulator
- Max 150mA output
- Over current
- Weighs less than
- DC input 5V up to
- On board Power
and Status LEDs
- Analog Pins: 8
- Digital I/Os: 14