If you not find your right product!      Write us email at   sales@component7.com.

4 Channel 5 Volt 10 Amp Relay Module

4 Channel 5 Volt 10 Amp Relay Module

4 Channel isolated 5 Volt 10 Amp relay module opto coupler for Raspberry Pi Arduino PIC AVR DSP ARM. This is a 5 Volt 10 Amp relay module is compliant with safety standards, control and load areas isolation trenches this relay is  genuine, can be used as a single chip modules can be used for appliance control; DC or AC signal, control, you can control the 220V AC load; there is a normally open and one normally closed contact.This relay can be controlled directly by Micro-controller (Raspberry Pi, Arduino, 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL logic).

Specification:

  • Each relay rated at 10A / 250V
  • Each relay consumes approx 30mA when switched on (at 12V)
  • One normally closed contact and one normally open contact
  • High impedance controller pin
  • Pull-down circuit for avoidance of malfunction
  • Power supply indicator lamp
  • Control indicator lamp
  • Channel: 4 channel
  • Relay Voltage: 5V

Note on the high level and low level triggered mode:

High-level trigger refers to the signal voltage between input and trigger, can be understood as a signal input with VCC cathode short-circuit triggered a way; Low-level trigger refers to the signal voltage between input terminal and Earth 0 Volt trigger, can be understood as signal input terminal and the GND negative electrode short circuit triggered a way  4-channel relay module connection Optically Isolated relays protect your microcontroller from damage if the equipment being controlled fails 5V 4-Channel Relay Interface Board, each one needs 15 – 20mA Driver current equipped with high current relays 10A 250VAC, DC30V 10A Relay output status indication by LED

Applications:

  • Standard Interface that can be controlled directly by Microcontroller (Raspberry Pi, Arduino, 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL logic) Multiple DIY projects
  • Electromagnetic relays are employed for the protection of various ac and dc equipment
  • Widely used for all MCU control Interface, Industrial sector, PLC control, Smart Home control, Home Automation, etc….

Write a review

Note: HTML is not translated!
    Bad           Good

  • Views: 1271
  • Product Code: 4 Channel 5 Volt 10 Amp Relay Module
  • Availability: In Stock
  • Rs249.00

Tags: optocoupler, relay, module, 5v, 10amp, 10a, channel, 4 channel

5 Volt PCB Mount DPDT Relay - 1 AmpThe Omron G5V-2 series are through hole signal relays. These ele..
Rs40.00

2 Channel isolated 5 Volt 10 Amp relay module opto coupler for Raspberry Pi Arduino PIC AVR DSP ARM...
Rs149.00

A resistor is a passive two-terminal electrical component that implements electrical resistance as a..
Rs1.00

A resistor is a passive two-terminal electrical component that implements electrical resistance as a..
Rs1.00

A resistor is a passive two-terminal electrical component that implements electrical resistance as a..
Rs1.00